Kako je mogoče obrabljena stopnišča hitro in profesionalno obnoviti in povezati brez topila?

Z UZIN NC 888 S in UZIN WK 222.

Stara stopnišča in podstavki niso samo neprijetno videti, temveč predstavljajo varnostno tveganje. Za dosego trajno varne rešitve s takojšnjo pripravljenostjo za promet je potrebno močno kontaktno lepilo s kratkim odprtim časom.

UZIN WK 222 je neoprensko lepilo na vodni osnovi za vsa kontaktna lepljenja, ki so običajna v gradbenih konstrukcijah. Izdelek izpolnjuje vse zahteve za zdravo klimo v zaprtih prostorih in ščiti zdravje monterja. Prednost UZIN WK 222: Uporablja se lahko enako kot tradicionalno kontaktno lepilo na osnovi topil. Turbo-izravnalna zmes UZIN NC 888 S, ki se hitro strdi, omogoča optimalno in hitro pripravo podlage. UZIN NC 888 S je mogoče enostavno in gladko obdelati ter ga nanesti na vodoravne in navpične površine. Luknje v lesenih površinah, estrihu in betonu je mogoče enostavno zapolniti, neenakomerno poravnati brez težav. Pripravljen za pokrivanje že po približno 30 minut (pri 20 ° C in 65% relativne vlažnosti).

Prenesi

Video o aplikaciji: Kako lahko obrabljena stopnišča hitro in profesionalno obnovimo in povežemo brez topila.

Galerija slik: Kako lahko obrabljena stopnišča hitro in profesionalno obnovimo in povežemo brez topila.

Prime calcium sulphate screeds and plaster levelling compounds as well as strongly absorbent, sanding substrates with the universal primer UZIN PE 360 PLUS.

Smoothen major undulations or roughnesses of the surface with low-slump Turbo Levelling Compound UZIN NC 888 S. Pour cold, clean water into a clean container. Sprinkle in the powder whilst mixing vigorously and mix until lump-free. Only mix as much mortar as can be applied within the working time of 5 - 10 minutes.

Apply the compound with the smoothing trowel uniformly up to the desired thickness onto the substrate. UZIN NC 888 S can be reworked or smoothed after approx. 15* minutes; the area is ready for covering after approx. 30 minutes (*at 20 °C and 65 % relative humidity).

Apply the solvent-free contact adhesive UZIN WK 222 with the enclosed yellow UZIN foam roller, coarse, and on the corners and edges use the UZIN silicon brush to apply adhesive uniformly thin onto the material to be bonded and the substrate. When applying the adhesive with the supplied 25 cm roller pre-spreading on a piece of chip board or the like is recommended in order to uniformly wet the roller.

Aerate both adhesive layers at least until they are almost non-tacky when touched. The covering side may alternatively be coated the day before. The second adhesive side is then aerated only until the surface is “slightly finger-dry”.

Put down the covering immediately or within the contact adhesion time, ensure correct fit and apply full area pressure, rub on or / and tap on. Subsequent correction is not possible. After 10 - 20 minutes* rub on again with force, especially seams and edges. (*at 20 °C and 65 % relative humidity).

S kratkim odprtim časom, takojšnjo nosilnostjo in vsestranskostjo je UZIN WK 222 zmagovalec v vseh pogledih. In UZIN NC 888 S izdeluje natančno vpojno podlago brez izgube časa.

Valentin Zeiler
Tehnične storitve UZIN