Kako lahko v skladu s pravili in standardi popravite fuge in razpoke v podlagi?

Z UZIN RR 203 in UZIN MK 92 S.

Razpoke in umetne fuge je treba zapolniti pred vgradnjo lesenih talnih oblog. Medtem ko so bili umetni spoji v površini namerno narejeni, pa razpoke predstavljajo poškodbe, ki imajo lahko različne vzroke. Da se fuge in razpoke ne bi kazale skozi leseni pod, jih je treba zatesniti. Preizkušeni sistem UZIN MK 92 S je v kombinaciji s sistemom za premostitev razpok UZIN RR 203 primeren za oba primera.

Prenesi

Obdelovalni film: Tesnjenje sklepov in razpok na lesenih tleh.

Galerija slik: Tesnjenje sklepov in razpok na lesenih tleh.

First grind the substrate with a WOLFF grinding machine to remove any materials that could impair adhesion.

Next, clean the area from dust and dirt using a powerful vacuum cleaner.

Prime the area containing the joint with UZIN PE 414 and leave to dry for approx. 2 hours.

Mix 2-component P-U-R wood flooring adhesive UZIN MK 92 S with a drill and stirrer attachment. Ensure its well mixed and spread immediately onto the substrate with B11 sized notch trowel.

Install the ready cut, UZIN RR 203 tile with the printed side facing up onto the fresh adhesive bed. Please note that the installation direction of the UZIN RR 203 tiles runs perpendicular to the joint. Alternatively, the roll material can be used instead of the tile material, but it must first be cut to size.

Use a WOLFF smoothing trowel to run over the crack bridge and then apply an even coat of UZIN MK 92 S. The wood flooring can now be installed as usual.

Alternatively, if applying a levelling compound, blind the wet adhesive with UZIN quartz sand 0.8. After the adhesive has set, vacuum the loose sand and install the levelling compound.

Lesena tla lahko namestimo na podlage, ki vsebujejo spoje in razpoke, če estrih ne popusti in je površina popravljena z UZIN MK 92 S v kombinaciji z razpokastim mostom UZIN RR 203.

Valentin Zeiler
Tehnične storitve UZIN