Kako lahko luksuzne vinilne ploščice hitro in zanesljivo namestimo na vlažne in onesnažene podlage?

Z UZIN RR 185 in Sigan Elements Plus.

Podloge z visoko preostalo vlago ali nečistočami iz olja in masti običajno zahtevajo dodelano in drago pripravo podlage. To delo je mogoče zaobiti z ojačitveno podlago UZIN RR 185. V kombinaciji s Sigan Elements Plus je ustvarjen edinstven sistem za popolno namestitev luksuznih vinilnih ploščic.

S kovinsko ojačanim posebnim lepilnim sistemom Sigan® Elements Plus lahko preprečimo množično migracijo mehčalca in tako zagotovimo dimenzijsko stabilne inštalacije. Nove talne obloge je mogoče namestiti hitro in enostavno, ne da bi povzročale prah, umazanijo ali hrup. Zato je idealen za uporabo v maloprodajnih okoljih, ker povzroča malo motenj. Sistem omogoča tudi nizko nabrano višino. V primeru prihodnje prenove lahko odstranite celoten sistem, vključno s talno oblogo, ne da bi pri tem ostali ostanki.

Prenesi

Obdelovalni film: Luksuzne talne obloge namestite na vlažne podlage.

Galerija slik: Luksuzne talne obloge namestite na vlažne talne podlage.

Remove any dust and dirt from the substrate using a powerful industrial vacuum cleaner. Unevennesses from the substrate may show through the new floor covering.

Roll out and precut the reinforcement underlay. Against all vertical structures leave a gap of at least 3 to 10 mm, depending on the floor covering and load. The side of the seams between the sheets do not need to be cut.

Apply the Sigan Elements Plus tape along the edges of the UZIN RR 185 reinforcement underlay. This provides increased adhesive strength in the edge areas.

Install the Sigan Elements Plus sheets across the UZIN RR 185 and roll down firmly.

Alternatively, Sigan can also be installed using the 2-man method.

If overlapping, the Sigan Elements Plus sheets must be cut back to the joint.

Mark the starting point of the first row of planks or tiles with a suitable pen on the protective paper. Place a steel rail along the measuring points and align. Pull the protective paper away from the Sigan Elements Plus and tear off the protective paper along the steel rail. The straight line thus creates a reference line of the first row of planks or tiles.

Without bending, install the planks or tiles along the reference line and press down firmly by hand. Keep pulling back the protective paper. Apply the floor covering bit by bit as described previously and roll over with the WOLFF Duo pressure roller.

After the installation roll over the whole area using the WOLFF pressure roller. The floor covering can be walked on and used immediately after installing.

The entire flooring system can be removed without leaving any residues, even after many years of use.

Sigan Elements Plus v kombinaciji z UZIN RR 185 je edinstven in inovativen sistem za popolno namestitev luksuznih talnih oblog na vlažne ali onesnažene podlage.

Valentin Zeiler
Tehnične storitve UZIN